User Tools

Site Tools


small_snap-lid_plastic_tubs_2

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
small_snap-lid_plastic_tubs_2 [2014/09/24 11:12]
nathalie
small_snap-lid_plastic_tubs_2 [2014/09/24 11:23] (current)
nathalie
Line 3: Line 3:
 {{:lecture:rubbermaid_take_along.jpg?200|}} {{:lecture:rubbermaid_take_along.jpg?200|}}
  
-  * **Description**:  +  * **Description**: Small tubs for holding leftovers. It is OK to reuse an existing tub, but once you have used it to hold electronic parts, solder and flux, you should not use it again to store food. 
-  * **Purpose**:  +  * **Purpose**: The tub will provide secure storage for your microcontroller and a breadboard project. The Sparkfun Inventor's Kit comes in a nice, reusable cardboard box. Depending on the size of your canvas tool bag, the Sparkfun cardboard box may be too large to fit inside the canvas bag along with the hand tools. In that case, the plastic tub (or tubs) will provide additional flexibility in storing and protecting the contents of the kit without needing to also fit the cardboard box inside the tool bag. 
-  * **Source**:  +  * **Source**: Various sources, including local hardware stores and chains such as Home Depot. 
-  * **Approximate Cost**: +  * **Approximate Cost**: $1 - $5
  
 [[equipment|back]] [[equipment|back]]
small_snap-lid_plastic_tubs_2.1411582368.txt.gz · Last modified: 2014/09/24 11:12 by nathalie